Bell EXPRESSVU Información técnica descargar pdf (Pagina 10)

Page 3-10

User Guide

Remote

Buttons Menu Options

1. Turn the receiver OFF and press either

CHANNEL UP or DOWN on the front

panel to display the System Information

screen. Note the Remote Address shown

on your TV screen in the screen that looks

like the example shown here.

2. Press and hold the SAT mode button until

all the mode button backlights come on (it

takes about three seconds). Release the SAT

mode button.

3. Use the number buttons to enter a number

from 1 to 15. Write down the new address.

4. Press the POUND button. If the address

you entered is valid for the remote control,

the SAT mode button backlight flashes

three times.

5. Point the remote at the receiver and press

the RECORD button. The Remote

Address on the System Information

screen should match the one you entered.

Note: If the Remote Address does not

change on the System Information

screen, press the RECORD button again.

6. To check the address programmed in the

remote, press and hold the SAT mode

button for three seconds. Then press the

POUND button twice. The SAT mode

button backlight flashes the same number

of times as the address.

7. Press the SELECT button to exit the

System Information screen.

4100_Ch3_eng 6/15/05 8:34 AM Page 10

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 55 56

Comentarios a estos manuales

Sin comentarios