Bell EXPRESSVU Información técnica descargar pdf (Pagina 29)

Page 3-29

Using The System

Using Timers

To set up receiver to control a VCR:

1. Press the MENU button.

2. Select the System Setup option.

3. Select the Installation option.

4. Select the VCR Setup option.

5. Set the VCR code by doing one of the following:

• Enter the 3-digit VCR code number, from the tables starting on page 4-11, using

the number pad buttons.

• Highlight each digit of the VCR code, and then press the Up or Down arrow button

until you reach the correct number and then press SELECT.

6. Make sure the VCR is connected to either the receiver phono audio/video outputs or

the TV Set Out Connection.

7. Make sure the VCR is turned on. Insert a rewound tape on which you want to record.

Note: The receiver only starts and stops the VCR recording, but does not turn ON the

VCR, so you must do this yourself.

8. To test the new code, highlight the Test option. The receiver displays a message

warning you to make sure the VCR is turned ON.

9. Press the SELECT button to start the test. Your VCR records for a few seconds, stops,

and then rewinds. The receiver displays a message saying that your VCR test is

complete. Follow the instructions on the message. If your VCR did not do the test,

enter another code from the table. Repeat step 8 and this step.

10.

Once you have found the correct VCR code, select the Done option to save the VCR

code you entered and return to the Installation and Setup menu.

4100_Ch3_eng 6/15/05 8:34 AM Page 29

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 55 56

Sin comentarios

Bell EXPRESSVU Información técnica Pagina 29