Bell EXPRESSVU Información técnica descargar pdf (Pagina 56)

TESTING THE SYSTEM

STARTING A TEST

Remote

Buttons Menu Options

1. Press the MENU button.

2. Select System Setup.

3. Select Diagnostics.

TELEPHONE CONNECTION TEST

This test checks that the receiver telephone connection is correct. Select the

Connection option to begin the test. The receiver displays a message asking you to

wait until the test is done.

• If the telephone connection is correct, the receiver displays a Phone Connection

OK message.

• If the receiver highlights the Done option, select the Dial Out option so the receiver

can make a toll-free call to the Customer Service Center. The receiver displays a

message asking you to wait until the call is done. When the call is done, select the

Done option to exit the test menu.

• If the telephone line is not connected properly, the receiver displays a failure message.

In this case, check the telephone connection and then repeat the test.

Note: If you have the receiver connected to a DSL (Digital Subscriber Line) phone

line, it may cause this test to fail. If so, you will need to install a DSL filter between

the receiver and the phone jack on the wall. You should be able to get a DSL filter

from your DSL provider, or your local electronic parts store.

Page 3-56

User Guide

4100_Ch3_eng 6/15/05 8:34 AM Page 56

1 2 ... 51 52 53 54 55 56

Sin comentarios

Bell EXPRESSVU Información técnica Pagina 56