Bell EXPRESSVU Información técnica descargar pdf (Pagina 43)

Page 3-43

Using The System

Resetting To Factory Default Settings

TURNING CALLER ID ON AND OFF

Remote

Buttons Menu Options

1. Press MENU on the remote control.

2. Select System Setup.

3. Select Installation.

4. Select Caller ID.

5. Select Enable Caller ID or select Disable Caller ID.

6. Select Done.

RESETTING TO FACTORY DEFAULT SETTINGS

Note: Resetting the receiver to factory default settings discards all Favourite Lists

except the All Chan and All Sub lists.

Note: If you have set any locks on the receiver, and the receiver is locked, these locks

will be kept. If the receiver is unlocked, any such locks will be lost; however, you cannot

reset the receiver to factory default settings to bypass a lock or to discard a password

you have forgotten. Call the Customer Service Center if you have forgotten your

password.

Complete the following instructions if you want to reset the receiver to be the same as

when it was shipped from the factory.

4100_Ch3_eng 6/15/05 8:34 AM Page 43

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 55 56

Sin comentarios

Bell EXPRESSVU Información técnica Pagina 43